Our Boat Dry Stacking is specially designed after we studied 200 boats, we created a rack to suit all types of Motor boats up to 5 Tons.
- The 1st level 5 ton
- the 2nd Level 3Ton
- Top Levl 1.5 Ton
- Bunks are designed at an Angle so that the rain water runs out
- The Ends are open allowing Inboard & outboard Boats to be loaded Safely
- All Levels are Adjustable
- DryStacks Constructed according to the Eurocode
The introduction of Nautiparks Marine Equipment of Boat Cradles, Boat Trailers and Dry stacking has made the concept of Dry Harbour more appealing.
The Dry Harbour Concept allows a field or land near to a river, lake or the sea to be transformed in to a Dry harbour at a very cost effective investment. The initial costs for the infrastructure would consist of a security fence, hard core, an office and the construction of a slipway.
For this concept to be efficient boats are lifted from the Yacht Cradle and taken to the slipway and launched within 10 minutes. In Brittany a Dry Harbour Marina Launches and picks up 300 boats a day using Three Nautipark “Quicklev Motor Boat Movers and two Fork Lifts.
Boat Hard standing areas do not have to be next to the water, One Dry Harbour has to drive Yacht Boat moving trailer 5km to the slipway to launch a Boat picks up another takes it back to the Dry Harbour power washes the hull and puts it back on its cradle and this is done by one employee.
Nautipark's expertise in design was used for the Racking Project at Fecamp. The Brief was that the Racks were acceptable to trhe Residents living in close proximity. The Racks were deisgned so as the residents saw only the ends which were clad in timber which covered and took the view of steel away.
Nautipark were involved of the Unique design and installation of the Racking at Lorient Dry Harbour in Brittany.. The Robotic project was built in the old SubmarineTunnels.
The boats are launched and picked up by a Quicklev Trailer and taken over to the cradle ready for the Robotic lift to pick up and put in its rack.
As you will see the Bunks are designed so as the inboard and outboard motors and different styles of keels can be stored easily.